RANGEHOOD & INSTALLATION GUIDE CL8812 Revision V2 (04.2017/v2.0) www.schweigen.com.
1. Welcome Thank you for purchasing this Schweigen appliance. To achieve the optimal performance from your appliance, and to avoid the risk of accident or damage, it is essential to read this manual before installation and first time use. This guide contains important information on the use and maintenance of the appliance, as well as important safety notes. Your appliance has been thoroughly checked for safety and functionality before being packaged and leaving the manufacturer.
Table of Contents 1. Welcome_____________________________________________________________________ 2 2. Important safety information____________________________________________________ 4 3. Description___________________________________________________________________ 7 4. Installation___________________________________________________________________ 8 5. Maintenance_________________________________________________________________ 13 6.
2. Important safety information Please read the instructions carefully. Only then will you be able to operate your appliance safely and correctly. Retain the instruction manual for future use or for subsequent owners. Check the appliance for damage after unpacking it. Do not connect or install the appliance if it has been damaged in transport. Any damage must be reported within 48 hours.
2. Important safety information Before Installation We recommend this appliance be installed or repaired by a qualified Schweigen Home Appliances technician. Please see our website www.schweigen.com.au for a list of our recommended installers. It is dangerous to modify any part of this appliance. Modification of any kind will immediately void the warranty. The manufacturer declines all responsibility in case of failure to adopt proper safety measures.
2. Important safety information Product Use The Rangehood has one mode of operation: Air extraction: The air is drawn in by the rangehood, filtered through the grease filters, and then expelled outside. Please check the cleaning and maintenance section for advice on the filter’s cleaning schedule. This product is designed for household use and must not be used for commercial applications. After use, always ensure that all controls are in the “OFF” position. Never flambé any food beneath the rangehood.
3. Description 1 Main Rangehood 1 Mounting Bracket 2 Power Cord 3 Upper Flue 4 Lower Flue 5 Pipe 6 Outlet (150mm) 7 Body 8 Lamp (GU 10 fitting) 9 Switch 10 Motor 11 2 3 4 5 6 7 10 8 Baffle Filter 9 11 NOTE: Filter and light quantity may vary from model to model.
4. Installation Mounting Laws and Regulations To be installed in an undercover alfresco area and/or indoor kitchen only. If the unit is not adequately covered or sheltered from the outside elements the warranty will be null and void. • The location of the installation must have permanent openings for ventilation. • Regulations concerning the expelling of air must be fulfilled. • It is STRONGLY RECOMMENDED that the rangehood be installed centrally over the cooktop, this will greatly improve its performance.
4. Installation Wall Mount Installation Every wall mounted rangehood has two primary mounting points and several secondary mounting points to firmly fix the rangehood in its place. Please ensure that the holes for the two primary mounting points are level before installation. Danger Always switch off and disconnect power before installing the rangehood. Failure to do so may cause serious injury. Mounting Points *Please refer to Specifications for mounting points measurements.
4. Installation Step 4 2 The outer and inner metal flue are encased one within the other. 1 Attach the flue wall mounting bracket to the correct position on the wall for the inner flue section to attach to at your desired height. Slide the inner flue cover (1), to the wall mounting bracket (2), and attach. NOTE: Please make sure that all plastic protection on the rangehood and filters are removed before use.
4.
4. Installation Roof Cowls / Roof Seal Kit WARNING All electrical wiring should be kept inside the roof space. 1 2 4 1 Roof Cowls* 2 Flexi Ducting must be pulled taut. DO NOT crush or kink the ducting. 3 Connect flexi ducting to the outlet on rangehood using aluminium foil tape and cable tie. Please DO NOT rip the ducting. 4 Main Power Lead (Male Plug) 3 *NOTE: Motor system does not include the roof seal kit/roof cowls, cable tie, duct tape or the support straps.
4. Installation Back Draft Fins Should your Back Draft Fins get stuck, this is not a warranty issue. When installing Back Draft Fins, please ensure that you insert the Back Draft Fins onto the back draft base, which are attached to the top of the motor outlet before installation. NOTE: Please make sure when ducting is installed, that it does not impede the Back Draft Fins from opening completely, otherwise poor extraction will occur. Back Draft Fins Back Draft Fins in Operation 5.
5. Maintenance Replacing the Light Bulb for CL8812 DANGER Always switch off and disconnect the power cord before replacing any light bulbs. Failure to do so may cause serious injury. Please be aware that the light bulb will retain heat for a short period of time after being switched off. Step 1 Step 2 Step 3 Remove the filters from the rangehood. Gently turn light bulb anticlockwise, pull the light bulb down and remove it from the light holder.
5. Maintenance Cooking with Induction Cooktops Cooking with an induction or similar cooktop, may produce condensation on the rangehood. Unlike basic electric or gas cooking, induction cooktops heat food and liquid instantly, which in turn, produces vapours rapidly. Because of the accelerated process, the rangehood filters do not have enough time to warm up, which increases the chance of condensation forming.
Please make sure there is no obstruction in ducting or with the back draft fins. Check the outlet, make sure it is not blocked and you have the correct diameter ducting installed. Check the ducting has not come off the rangehood outlet or has been eaten through by rodents. X X X X Rangehood does not direct air out (through chimney) X X Rangehood does not work X X Light does not work X Loud noise from the rangehood Page 16 Check light bulbs. Make sure they are not broken or faulty.
5. Maintenance Calling the Technical Assistance Service Hotline In the event that the failure is not due to the faults mentioned in Trouble Shooting, contact Customer Service. In Australia, Customer Service 1300 829 066 In New Zealand, Customer Service 0800 200 510 Lodging an online Service Request In the event that failure is not due the reason/s in the trouble shooting section, you can lodge an online Service Request. To lodge a Service Request, visit our website www.schweigen.com.
6. Specifications Technical Specifications Model CL8812 Feeding Voltage 220-240V 50Hz Lamp Power 3 LED x 3.
7. Disclaimer Under our policy of continuous product development, product specifications may change without notice. Prospective purchasers should therefore check with the retailer to ensure this publication correctly describes the products being offered for sale.
Australia 8/3-4 Anzed Court, Mulgrave 3170 Victoria. Phone 1300 881 693 Email sales@schweigen.com.au Web www.schweigen.com.au New Zealand 5 Tolich Place, Henderson, Auckland 0610. Phone 0800 200 510 Email info.parex@emerson.com Web www.parex.co.nz SCH00015 Distributed by Axis Group International Pty Ltd.
