Owner`s manual

GP-MSJW-CX-07B

STW-JZ / IW Manual

RD: Sept, 2005

RL: 7B

Page 11

FIGURE 10 BOLTING BURNER TO FLANGED TUBE

• Align the four bolts through the

flange adapter on tube flange, se-

cure tightly with lock washers

and nuts

• Do not loosen or remove fifth nut

(#1) directly below burner cup

• Secure suspension chain to eye

hook in order to stabilize burner

with chain in angled position

HEATER SHOULD BE SPACED AWAY FORM A WALL OR OB-

STRUCTION THAT WOULD RESTRICT OR LIMIT ACCESS TO

THE SIDES OF THE BURNER PANEL FOR SERVICE OR REPAIRS.

(SEE PRE-INSTALLATION SURVEY AND MOUNTING CLEARANCES)

b) Adjust the hanger so that it is located on the second tube, approximately 2” from the end

of the tube – in this location the hanger supports both tubes.

c) Slide the Torctite coupler into position across the center of the joint

d) IMPORTANT: TOURQUE THE COUPLER BOLTS TO 40 FT-LBS

e) The coupler is now in place on the ‘burner-end’ side of the hanger

8) CHECK THAT THE SECOND TUBE IS LEVEL, ALIGNED HORIZONTALLY AND

VERTICALLY WITH THE FIRST TUBE – MAKE ADJUSTMENT AT SUSPENSION

POINTS AS REQUIRED

9) Install the reflector over the second tube fastening to the hangers at each end

10) Repeat the previous steps assembling one section of tube and reflector at a time until the

system is complete

11) ENSURE THAT THE SYSTEM IS LEVEL AND THAT ALL TUBES ARE ALIGNED

HORIZONTALLY AND VERTICALLY – MAKE ADJUSTMENT AT SUSPENSION

POINTS AS REQUIRED

12) Mount the Burner to the first tube flange using the four nuts and bolts provided

a) TIGHTEN THE BOLTS IN AN OPPOSITE CORNER SEQUENCE AND ENSURE

THAT THE BURNER IS IN HORIZONTAL ALIGNMENT WITH THE TUBE

13) The ‘center of gravity’ of the burner is slightly off-center to the tubes. So, in order to pre-

vent side rotation of the burner:

Install a support chain from the eye hook on the burner to a point approximately 8 to 10

inches away (towards the burner) from the first tube hanger

i) DO NOT fasten the chain from the burner to the first hanger suspension point

ii) The chain will angle back over the burner and allow “straight back” movement of

the burner when the system heats up and expands