Owner`s manual

P40U / P40U-I &O Manual

IM101220

RD: DEC 2011

RL: 1A - BA

Heater Expansion

It is a normal condition that during heat-up and cool-down a tube

heater will expand and contract. Allowances for heater expansion

must be made in the gas connection, venting and combustion air

ducting. Improper installation, alteration, or adjustment can result in

WARNING

Venting

Inadequate venting of a heater may result in asphyxiation, carbon

monoxide poisoning, injury or death. This heater may be directly or

indirectly vented from the space. Venting must be in accordance with

all local, state, provincial, and national codes (ANSI Z223.1/NFPA 54 in USA;

B149.1 in Canada) and as indicated in this manual. Refer to Sections 11 & 12

Gas Connection

Improper installation, connection, or adjustment can result in property

damage, toxic gases, asphyxiation, injury or death. Use the approved

Type 1 hose gas connector supplied with the heater to connect the

heater to the gas supply. The gas supply must be connected tested in accordance with all lo-

cal, state, provincial, and national codes (ANSI Z223.1/NFPA 54 in USA; B149.1 in Canada)

and as indicated in this manual. Refer to Section 13

WARNING

Start-Up ‘SMOKE’ Condition

During start up, the heating of material coatings used in the production process of tubes and

reflectors will create smoke during the initial period of operation. This condition is normal and

temporary .

Ensure that there is sufficient ventilation to adequately clear any smoke from the space.

Notify site and safety personnel to ensure that alarm systems are not unduly activated.

WARNING