Operating instructions

ManualsBrandsSchwank ManualsHeaterinfraSchwank D 40U

infraSchwank D / calorSchwank D - shape U

Version 005 infra_calor D shape U Australia 42/14 Technical specification subject to change

Note the following points while installing the

gas-pipe-system:

 Use only gas lines as per national standards,

refer to AS 5601 for pipe size details.

 Never hang heaters on the gas pipes.

 Mount a manual gas cock upstream of every

radiant tube.

 Close all gas cocks before carrying out the leak

test and disconnect the connection between the

gas cock and the burner to avoid damages to the

gas regulator and gas combination valve.

 Clean gas pipes before the installation of the

heater. Reconnection after pressure control and

expansion.

Please observe the national standards.

Connect the heater with an approved

flexible hose.

 Use the following hose length:

 Mount only a flexible hose with 90° bend or with

2 x 90° elbow with 180° bend according to

fig. 20, 21 and 22.

 Keep the specified installation dimensions.

 Wrong mounting of flexible hoses shown in

Fig. 23 (sketches

 to)

Fig 20: Stand connection 90° bend

Fig 16: lateral connection 90° bend

Fig. 21: lateral connection 90° bend

Fig. 22: Alternative flexible hose 180° -bend with 2 x 90° elbow

Fig 23: Wrong mounting of flexible hoses

15-30U R ½“ length 800mm

40U R ¾“ length 800mm

a = 320 mm +/- 10%

h = 150 mm

h: allowable height

displacement for mounting

430 mm

(+/- 10%)

430 mm

(+/- 10%)

430 mm

- 10%)

430 mm

(+/- 10%)





