User guide
13
IM110526
RD: JUNE 2011
RL; 1A
BA
InfraSave IEP-1520 Manual
7. MAINTENANCE INSTRUCTIONS
WARNING
Heater service should only be performed by a qualified electrician. Fail-
ure to comply could result in personal injury, death, fire and/or property
damage.
Tampering with the heater by an unqualified person will void the warranty.
WARNING
Always unplug or disconnect the heater from the electrical power supply
prior to any cleaning, maintenance or service work.
Never immerse the appliance in water! Danger to life!
CAUTION: The Heat Lamp is fragile. Handle the heater with care so as
not to damage the Heat Lamp. Never touch the Lamp with bare fingers. Oils
from your skin will damage the Lamp.
Inspect the heater and cord prior to each use:
Clean any accumulation of dust or dirt from surfaces and in particular from the reflector
and any air openings in the heater body (refer to Cleaning section below).
Any damaged parts or components must be repaired or replaced prior to operation.
Service and Repair:
Disconnect the heater from the power source prior to servicing
Important: All repairs must be referred to qualified electrician!
Repairs carried out improperly or by an unqualified person may have serious conse-
quences for the user!
Any tampering with the appliance will invalidate the warranty.
8. CLEANING
Before cleaning - Disconnect the heater from the power supply and allow to cool.
Do not touch the Heat Lamp with your fingers - oil from your skin will damage the Lamp.
To clean the heater surface, reflector, and air inlets: Use only a dry or damp cloth or
low pressure air stream (computer ‘duster’ in a can).
Do not use any abrasive or caustic cleaning agents.
Never immerse the appliance in water! Danger to life!
If a heater is exposed to water have a qualified electrician inspect and repair the heater
prior to use.
Inspect the electrical cord and plug for damage or fraying.
Do not operate the heater with a damaged cord or plug.
Have damaged parts replaced by a qualified electrician