User manual

9
MODE-LED
LED
for the
respective
satellite
Meaning
„off″ „off″ The SAT-Finder HD hasn’t locked on to a
transponder.
„ashing″ „off″ The SAT-Finder HD has locked onto a trans-
ponder, but no satellite has been identied
yet or not enough data/information has been
received.
„ashing″ „ashing″ The SAT-Finder HD has locked onto a trans-
ponder and is analysing its data.
Based on the data analysed so far the
SAT-Finder HD assumes that the satellite dish
is aligned with the satellite shown by the LED.
„on″ „on″ The SAT-Finder HD has locked onto a trans-
ponder, all necessary data has been received
and processed.
Based on the information received the satellite
will by shown by its corresponding LED.
„on″ „ashing″ Special case:
The SAT-Finder HD has locked onto a trans-
ponder and analysed all the data received.
However, either not all the necessary data
could be received or there were discrepancies
in the received information.
The SAT-Finder HD will show by LED what it
assumes to be the correct satellite based on
the data received.
„on″ „off″ Special case:
The SAT-Finder HD has, as in the previous
case, completed analysed of the data. Based
on the data, either no satellite could be
identied or the satellite is one that is not
included on the SAT-Finder HD display.
In this case the unit will try to tune to other
transponders in order to start a new attempt at
identifying the satellite.
3.4 Satellite position display
Satellite display works similarly to the display of operating/search mode,
using the status ″off”, ″ashing” and ″on”, with meanings as shown in the
following table:
BDA_SF9002_GB.indd 9 18.03.14 09:27