User manual

8
2.4 Switchable Signal Attenuation
With strong satellite signal all LED‘s are switched on for the level and quality
function of the Satnder display. Please use the attenuator function. You can
reduce the signal by -5dB or-10dB to improve the ne tunning by using the
level and quality display of the Satnder HD. Pressing the B button for 2
seconds you can reduce the attenuation of the signal by -5dB and when you
press the button for 4 seconds, you can reduce the attenuation of the signal
by -10dB.
2.5 Reset
If you press both buttons together and hold them down for approx. 5 seconds,
this will reset the SAT-Finder HD.
3. INDICATOR LED’S
3.1 Level (signal strength)
Signal strength is displayed to the user via 8 LEDs. Each LED can either be
″off”, ″ashing slowly”, ″ashing quickly” or ″on”.
3.2 Quality (signal quality)
Signal quality is displayed to the user via 8 LEDs.
3.3 Mode (mode of operation)
This LED shows the conditions of the attenuation of the signal. In -5dB, the
LED lights green at -10dB, the LED lights up red
BDA_SF9002_GB.indd 8 18.03.14 09:27