User manual

5
1.3 Connecting the SAT-Finder HD
Please connect the „LNB” marked socket of the Sat-Finder HD through the
supplied coaxial cable and BNC adapter directly to the LNB.
Suitable LNB types:
Single-LNB
Twin-LNB
Quad-LNB
Quattro-LNB
Monoblock LNBs
Unicable-LNB (legacy-port)
If the SAT-Finder HD is to be connected directly to a Quattro-LNB, use the
following table to connect it to one of the four LNB outputs so that the desired
satellite can be identied. For other satellite positions you will see the current
setting on www.schwaiger.de
1.4 Start-up process
Please charge before the rst using the Sat-Finder HD completely. After the
complete charging, the red LED will disable. Now you can use the Sat-Finder.
Please put the „On” Button for booting.
The Red LED ashes when the battery capacity is too low. In this level the
battery still has a capacity of approximately 35% of their total capacity.
Please recharge the Sat-Finder HD.
After approx. 3-5 seconds the unit’s rmware has been loaded into its RAM
memory and component initialisation will begin. Subsequently, all LEDs will
light up briey and the SAT-Finder HD is ready for use.
The entire start-up process takes around 7 seconds.
BDA_SF9002_GB.indd 5 18.03.14 09:27