Instructions

9
Re-start the network
This function will permit the user to reset the network connection settings to factory settings.
Once the network has been restarted, the gateway will be restarted. Once the network cable
has been connected to the gateway after the network has been restarted, it will continue to
use the network connection. If the network cable has not been connected to the gateway, the
gateway will enter Access Point mode. Tapping the 3 button and holding it for 5 to 15 seconds
will reset the network configuration.
Factory settings
The factory settings function will reset the gateway to the state in which it was delivered. Doing
so will delete all of the saved data. Furthermore, all saved Z-Wave and ZigBee settings will be
deleted as well as the scenarios already created. Tapping the 3 button and holding it for 15 to
30 seconds will reset to the factory settings.
4.8 HA101 Button Assignments
The HA101 gateway has 3 buttons (numbered in sequence), which have each been assigned
an LED. Certain features will be activated by tapping and holding the button for longer periods
of time. Each buttons has been assigned a special feature.
• Button 1: Managing the Z-Wave network
• Button 2: Managing the ZigBee network
• Button 3: System settings (reset)
Z-Wave learning mode
To enable the Schwaiger Home Gateway to add a new Z-Wave sensor, select learning mode.
Tap the 1 button for Z-Wave components and hold it for 1 to 5 seconds to start learning mode.
If a Z-Wave sensor should be removed, tap the 1 button (and hold it for 10 to 30 sec.) to
remove the components from the gateway.
ZigBee learning mode
Follow the same procedure for the Z-Wave mode in order to register ZigBee components. Of
course, the 2 button will be used for this feature (see the tables as well). The LEDs also provide
information about the status of the gateway.
In the Access Point mode, all three LEDs will be turned on at a frequency of 2 Hertz. When
starting the gateway, only the LED for the 1 Button will be turned on. Booting takes roughly
2 minutes.
Green
Green
Green
Blinks 20Hz
Blinks 2Hz
until network
is opened
Blinks 2Hz
until network
is opened
Blinks 2Hz
Blinks 4Hz Blinks 10Hz
Factory reset
Open network
Open network
Open network
for exclusion
Learn modeClose network
Close network
Reset Reset network
Blinks 4Hz
until network
is closed
Blinks 4Hz
until network
is closed
Blinks 10Hz
until network
is closed
0Sec. 1 5 10 15 20 30
Button 1 Z-WaveZigBeeSystem
Button 2Button 3