User manual
Table Of Contents
- CONTENTS
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- PROGRAMMES
- SETTINGS
- OPTIONS
- BEFORE FIRST USE
- DAILY USE
- HINTS AND TIPS
- CARE AND CLEANING
- TROUBLESHOOTING
- Technical problems
- Poor washing results
- Poor drying results
- Traces of rust on cutlery
- Limescale deposits on the tableware, on the tub and on the inside of the door
- Visible bluish film on glasses and cutlery, on the tub and on the inside of the door
- Chipped tableware
- Excess of moisture on the baskets and inside the appliance
- Odours inside the appliance
- The lid of the detergent dispenser does not close properly
- There are residues of detergent in the dispenser at the end of the programme
- Unusual foam during washing
- Items that are dull, discoloured or with a non washable patina
- TECHNICAL INFORMATION
- INHALTSVERZEICHNIS
- SICHERHEITSINFORMATIONEN
- SICHERHEITSANWEISUNGEN
- GERÄTEBESCHREIBUNG
- BEDIENFELD
- PROGRAMME
- EINSTELLUNGEN
- OPTIONEN
- VOR DER ERSTEN INBETRIEBNAHME
- TÄGLICHER GEBRAUCH
- TIPPS UND HINWEISE
- REINIGUNG UND PFLEGE
- FEHLERSUCHE
- Technische Störungen
- Nicht zufriedenstellende Spülergebnisse
- Nicht zufriedenstellende Trocknungsergebnisse
- Rostspuren am Besteck
- Kalkablagerungen auf dem Geschirr, im Innenraum und auf der Türinnenseite
- Sichtbarer blauer Belag auf Gläsern und Besteck, im Innenraum und an der Türinnenseite
- Angeschlagenes Geschirr
- Extreme Feuchtigkeit in den Körben und im Geräteinneren
- Gerüche im Gerät
- Der Deckel des Reinigungsmittelbehälters ist nicht richtig geschlossen.
- Am Ende des Programms befinden sich Reinigungsmittelreste im Behälter.
- Ungewöhnliche Schaumbildung während des Spülgangs
- Geschirr wird blind, verfärbt sich oder Beläge sind nicht abwischbar.
- TECHNISCHE DATEN
Programme
1)
Water
(l)
Energy
(kWh)
Duration
(min)
10 0.9 30
8.5 0.910 170
11 - 12 0.7 - 0.9 70 - 80
4 0.1 14
1)
The pressure and the temperature of the water, the variations of the mains supply, the options and the quantity of
dishes can change the values.
Information for test institutes
For all the necessary information for test
performance, send an email to:
info.test@dishwasher-production.com
Write down the product number (PNC) that
is on the rating plate.
SETTINGS
Programme selection mode and
user mode
When the appliance is in programme
selection mode it is possible to set a
programme and to enter the user mode.
In user mode, the following settings
can be changed:
• The level of the water softener according
to the water hardness.
• The activation of the rinse aid dispenser
when you want to use the Multitab
option and the rinse aid together.
These settings will be saved until you
change them again.
How to set the programme
selection mode
The appliance is in programme selection
mode when all the programme indicators
are on and the display shows 2 horizontal
status bars.
When you activate the appliance, usually it
is in programme selection mode. However,
if this does not happen, you can set the
programme selection mode in the following
way:
Press and hold cancel until the appliance is
in programme selection mode.
The water softener
The water softener removes minerals from
the water supply, which would have a
detrimental effect on the washing results
and on the appliance.
The higher the content of these minerals,
the harder your water is. Water hardness is
measured in equivalent scales.
The water softener should be adjusted
according to the hardness of the water in
your area. Your local water authority can
advise you on the hardness of the water in
your area. It is important to set the right
level of the water softener to assure good
washing results.
8