User manual
Table Of Contents
- CONTENTS
- SAFETY INFORMATION
- SAFETY INSTRUCTIONS
- PRODUCT DESCRIPTION
- CONTROL PANEL
- PROGRAMMES
- SETTINGS
- OPTIONS
- BEFORE FIRST USE
- DAILY USE
- HINTS AND TIPS
- CARE AND CLEANING
- TROUBLESHOOTING
- Technical problems
- Poor washing results
- Poor drying results
- Traces of rust on cutlery
- Limescale deposits on the tableware, on the tub and on the inside of the door
- Visible bluish film on glasses and cutlery, on the tub and on the inside of the door
- Chipped tableware
- Excess of moisture on the baskets and inside the appliance
- Odours inside the appliance
- The lid of the detergent dispenser does not close properly
- There are residues of detergent in the dispenser at the end of the programme
- Unusual foam during washing
- Items that are dull, discoloured or with a non washable patina
- TECHNICAL INFORMATION
- INHALTSVERZEICHNIS
- SICHERHEITSINFORMATIONEN
- SICHERHEITSANWEISUNGEN
- GERÄTEBESCHREIBUNG
- BEDIENFELD
- PROGRAMME
- EINSTELLUNGEN
- OPTIONEN
- VOR DER ERSTEN INBETRIEBNAHME
- TÄGLICHER GEBRAUCH
- TIPPS UND HINWEISE
- REINIGUNG UND PFLEGE
- FEHLERSUCHE
- Technische Störungen
- Nicht zufriedenstellende Spülergebnisse
- Nicht zufriedenstellende Trocknungsergebnisse
- Rostspuren am Besteck
- Kalkablagerungen auf dem Geschirr, im Innenraum und auf der Türinnenseite
- Sichtbarer blauer Belag auf Gläsern und Besteck, im Innenraum und an der Türinnenseite
- Angeschlagenes Geschirr
- Extreme Feuchtigkeit in den Körben und im Geräteinneren
- Gerüche im Gerät
- Der Deckel des Reinigungsmittelbehälters ist nicht richtig geschlossen.
- Am Ende des Programms befinden sich Reinigungsmittelreste im Behälter.
- Ungewöhnliche Schaumbildung während des Spülgangs
- Geschirr wird blind, verfärbt sich oder Beläge sind nicht abwischbar.
- TECHNISCHE DATEN
Problem/alarm code Possible solution
The remaining time in the dis-
play increases and skips
nearly to the end of pro-
gramme time.
• This is not a defect. The appliance is working correctly.
The appliance door is difficult
to close.
• Parts of the tableware are protruding from the baskets (e.g.
pot or pan handles, ladles).
Rattling/knocking sounds
from inside the appliance.
• The tableware is not properly arranged in the baskets, items
are touching each other.
• One or both spray arms are touching the tableware while
turning. Make sure that the spray arms can rotate freely oth-
erwise the cleaning results will be heavily affected.
The appliance trips the cir-
cuit-beaker.
• The amperage is insufficient to supply simultaneously all the
appliances in use. Check the socket amperage and the ca-
pacity of the meter or turn off one of the appliances in use.
• Internal electrical fault of the appliance. Contact an Author-
ised Service Centre.
The appliance does not fill
with water.
The display shows the alarm
code .
• Make sure that the water tap is open.
• Make sure that the pressure of the water supply is not too
low. For this information, contact your local water authority.
• Make sure that the water tap is not clogged.
• Make sure that the filter in the inlet hose is not clogged.
• Make sure that the inlet hose has no kinks or bends.
The appliance does not drain
the water.
The display shows the alarm
code .
• Make sure that the sink spigot is not clogged.
• Make sure that the filter in the outlet hose is not clogged.
• Make sure that the drain hose has no kinks or bends.
The anti-flood device is on.
The display shows the alarm
code .
• Close the water tap and contact an Authorised Service Cen-
tre.
Once the controls have been done,
deactivate the appliance and wait 5 minutes
before activating it again. If the problem
persists or the alarm code continues to
appear, contact an Authorised Service
Centre.
When you contact the Service
Centre always remember to give
the alarm code (when available).
Poor washing results
• The baskets have been overloaded.
• Tableware has not been properly
arranged.
• The quantity of detergent was not
enough.
• The detergent was not suitable or old.
• The programme was not appropriate for
the degree of soil and the type of load.
• The spray arms were blocked by the
tableware and could not rotate freely.
• The spray arms are clogged.
• The filters are clogged or not positioned
correctly.
18