User Manual

The EZ Sensor is manufactured by the grantee (Schrader Electronics) and sold as an

OEM product to automobile dealerships and tire installers. Per 47 CFR 2.909, 2.927,

2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all applicable

/ appropriate operating instructions. When end-user instructions are required, as in the

case of this product, the grantee must notify the OEM to notify the end user.

Schrader Electronics will supply the following user’s manual to the

reseller/distributor and require them to provide this information to the end user at the

time of installation.

PAGE 1
The EZ Sensor is manufactured by the grantee (Schrader Electronics) and sold as an OEM product to automobile dealerships and tire installers. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure the end-user has all applicable / appropriate operating instructions. When end-user instructions are required, as in the case of this product, the grantee must notify the OEM to notify the end user.
PAGE 2
EZ Sensor END CONSUMER USER MANUAL The Schrader Electronics EZ Sensor is a configurable sensor designed to be used in a direct measurement TPM (Tire Pressure Monitoring) System. The TPM Sensor is intended to interface to a receiver/decoder that has been designed to accept the TPM sensor protocol. The TPM Sensor is designed to monitor a vehicle's tyre pressure whilst driving or stationary.