User's Manual

The device under test is manufactured by the grantee (Schrader Electronics) and sold as an
OEM product. Per 47 CFR 2.909, 2.927, 2.931, 2.1033, 15.15(b) etc…, the grantee must ensure
the end-user has all applicable / appropriate operating instructions. When end-user instructions
are required, as in the case of this product, the grantee must notify the OEM to notify the end-
user.
Schrader Electronics will supply this document to the reseller/distributor dictating what must
be included in the end user’s manual for the commercial product.
INFORMATION TO BE INCLUDED IN THE END USER'S MANUAL
The following information (in blue) must be included in the end product user’s manual to
ensure continued FCC and Industry Canada regulatory compliance. The ID numbers must
be included in the manual if the device label is not readily accessible to the end user. The
compliance paragraphs below must be included in the user's manual.
******************************************************************************
FCC ID:MRXAFFPK4 IC: 2546A- AFFPK4
This device complies with Part 15 of the FCC Rules and with Licence exempt RSS standards of
Industry Canada. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received, including interference that may cause
undesired operation.
Any changes or modifications not expressely approved by the party responsible for
compliance could void the users authority to operate the equipment.
NOTE:This equipment has been tested and found to comply with the limits for a class B
digital device ,pursuant to Part 15 of the FCC Rules.These limits are designed to provide
reasonable protection against harmfull interference in a residential installation..This
equipment generates ,uses and radiates radio frequency energy and,if not installed and used