Product Manual

Visual and Audible Indicators

The information display areas for the transmitter are easy to understand. In addition, the

transmitter has an audible indicator to provide feedback and warnings to the user in

certain situations.

All visual indicators for the transmitter are on the LCD display, which has four general

areas to display information to the user: a battery indicator, a large 3-digit numeric display,

a frequency display, a power level indicator, mode indicators, and several unit indicators.

• BATTERY INDICATOR - The "Battery" symbol indicates the transmitter's

battery status. When all 3 segments inside the battery symbol are present, the

battery is fully charged. When only the 2 bottom segments are present, the

battery has a medium charge. When only the bottom segment is present,

the battery has a low charge and should be recharged as soon as possible.

If there are no segments present, the battery is extremely low and it should

be recharged immediately. If the battery reaches a voltage dangerously close

to the level where continuous operation can damage it, the empty battery box

will begin to flash and transmitter shutdown is imminent. In addition, the

battery indicator is used to show that the charger is plugged in correctly;

the battery box will be on with all 3 segments rolling. See section Battery

Charger below for additional information on the battery charging visual

indicators.

• 3-DIGIT NUMERIC DISPLAY - This area is used to display

operating mode information as follows:

 Ind Transmitter operating in the Inductive mode

 CLA Transmitter operating in the Inductive Clamp mode

 xxx mA Transmitter operating in the Conductive mode; the display

shows the output current in milliamps

 XXX A 3-digit number displayed momentarily on power up

indicating the current software version (i.e. 121 = Version

1.21).

See section Line Voltage and Impedance Measurement for additional uses of

this display area when measuring line voltage and impedance.

• FREQUENCY DISPLAY – The upper left of the LCD consists of 4 icons: "512 Hz”, “33 kHz",

"82 kHz", and "Passive Arrow". The lower center of the LCD contains the “SONDE” icon.

• POWER LEVEL INDICATOR – This area is a bar graph display used to display the

output power level setting in conductive mode. The output power levels are displayed

as follows:

1 bar 0.5 W

2 bars 1 W

3 bars 2 W

4 bars 5 W