Schonstedt Instruction Manual

20

battery indicator will “roll”. As shown below, when the battery is fully charged, it will
display “bAt FUL” on the LCD. If the power is OFF, the battery will still charge, but no
indication of charging activity or battery status will be shown on the LCD.
If the battery charger is not charging the battery successfully, the following indication
will be shown on the LCD:
The battery may not successfully charge for a number of reasons: the battery may be
overcharged, the battery may not be taking a charge in a reasonable amount of
time, the battery may be too warm to be charged without causing damage to its
internal cells, or the battery charger may have an internal fault.
If the error message comes on, take the following steps to try to clear the condition:
1. Remove the power connector from the charger, and reconnect it to start the
charger.
2. If the transmitter is warm, move it to a conditioned space, and allow it to cool for
several hours before attempting to charge again.
3. If the error message remains on after the steps above, contact Schonstedt
Instrument Company for further instructions. Also, please refer to the Battery
Replacement portion of this manual.