User's Guide
3) Plug the small end of the charging cable into the earbuds USB Charging Port.
4) Plug the other end of the charging cable into a USB wall charger or computer that is powered on.
5) When charging, the LED Indicator will show a red light.
6) When the earbuds are fully charged, the LED indicator will show a blue light.
7) After the earbuds are fully charged, remove the charging cable from the USB wall charger or
computer, then remove the earbuds from the charging cable.
8) Make sure the earbuds are fully charged before use. Repeated undercharging of the earbuds will
cause degradation of the battery performance.
9) Charge the earbuds upon hearing the “Battery Low” voice reminder.
Note: It takes approximately 1.5–2 hours to fully recharge the earbuds. Once the LED Indicator
shows a blue light, remove the earbud from the charging cable to avoid overcharging. DO NOT
overcharge the earbuds; it may cause overheating. Keep your earbuds and charging cable in a well-
ventilated area when in use or charging.
Pairing the earbuds with your cell phone:
1) Make sure the earbuds and your cell phone are next to each other.
2) Turn on the earbuds by pressing and holding the Multiple Function Button (MFB) for about 3
seconds, until the blue light flashes with voice prompts “Power On”.
3) Release the MFB, then the earbuds will enter into pairing mode automatically, with its blue & red
lights flashing alternately.
4) Go to your cell phone’s Bluetooth section and turn on the Bluetooth function.
5) The earbuds pairing name is “Bluetooth Music”, search and click on “Bluetooth Music” from your
Bluetooth section to connect.
6) After the earbuds connect with your cell phone successfully, a voice will prompt “Connected”, and
the LED Indicator will flash a blue light intermittently.
7) If the Bluetooth function is turned on to the last paired device, the earbuds will automatically
connect with voice prompt “Connected”.
8) If your earbuds haven’t been used for a long time, they may need to connect manually again. If
this is the case, follow steps 1–5.
Note:
Due to different phone compatibility, some cell phones may need to input “0000” to authorize the
pairing.
When the earbuds are on, but not paired with your cell phone, the earbud will exit the pairing
mode and will automatically turn off in 10 minutes.
How to Use:
Power On
If the earbuds are off, press and hold MFB for 3–5 seconds to turn on.
You will see a blue light flash and hear the “Power On” voice prompt.
Power Off
Press and hold MFB for 3–5 seconds to turn off the earbuds. You will
see a red light flash and hear the “Power Off” voice prompt.
Pairing Mode
After turning on the earbuds, they will automatically enter into pairing
mode. To pair the earbuds with your cell phone, please refer to “Pairing
the earbuds with your cell phone” section above.