Installation Manual

4
Copyright © 2014-15 Schneider Electric. All Rights Reserved.
All trademarks are owned by Schneider Electric Industries SAS or its affiliated companies.
solar.schneider-electric.com
Conext™ Mini Power Distribution Panel Installation Guide
865-1013-01
DC+
Ground
DC–
Neutral
LOAD BYPASS GRID
LI N L2
LOAD
LI N L2
GRID
(AC1)
LI N L2
GEN
(AC2)
AC OUT AC IN AC IN
Add UL/CSA approved strain relief
clamps to knockout holes.
Add UL/CSA approved strain relief
clamps to knockout holes.
AC LOADS
AC SOURCE
NOTE: Connect the pre-installed AC wires (6 pieces)
provided with the Mini PDP to the inverter’s AC and
Ground terminals. All other wires and/or cables are not
provided.
NOTE: All wires, cables, and breakers in this
illustration are not provided with the Mini PDP.
See section B Materials List for information on DC
breakers.
Connect the labeled wire
ends to the XW/XW+ unit’s
AC and Ground terminals
(as shown).
Install AC wires (not
provided) between the L1
and L2 bypass terminal
lugs AND the AC load box.
Route the wires through
one of the knockout holes.
Install DC cables (not
provided) between the battery
terminals and the Mini PDP’s
battery terminal lugs.
Install AC wires (not
provided) between the L1
and L2 bypass terminal lugs
AND the AC source box.
Route the wires through one
of the knockout holes.
Connecting AC wires to the inverter Connecting Generator AC wires to a fourth AC breaker and to the Inverter
DC+ DC–
BYPASSGEN
LI N L2
LOAD
LI N L2
GRID
(AC1)
LI N L2
GEN
(AC2)
AC OUT AC IN AC IN
Connect L1 and L2 wire
ends to the AC2 terminals
(GEN) (as shown).
Install a fourth AC breaker
(not provided) in the
highlighted slot.
Connect L1 and L2 wire
ends to the breaker
output terminals (as
shown).
Connect L1 and L2 wire
ends to the breaker
input terminals.
Connect L1 and L2 wire
ends to the generator’s
AC OUT terminals.
GENERATOR
CONNECTION ONLY
Use either bolted
or screw terminals.
Torque according
to posted guide-
lines.
(1st pair)
(2nd pair)