Product Manual

Configuring Advanced Settings
975-0636-01-01 Rev E 4–23
AC Support Settings
AC Support settings contain configuration options for grid-interactive operation
including AC support mode, load shaving (also applicable to generator only AC
source), and enhanced AC support for DC coupled systems.
Table 4-15 Setting Defaults and Ranges
Model All Models
Item Default Min Max
ACIn Breaker 30A 5A 30A
ACIn Lo Volt 170V 170V 220V
ACIn Hi Volt 270V 240V 270V
ACIn Lo Freq 45Hz 40Hz 48Hz
ACIn Hi Freq 55Hz 52Hz 68Hz
Table 4-16 AC Settings menu
Item Description
ACIn Breaker
Sets the AC Input breaker size, based on the size of the installed AC
breaker. The breaker size must not exceed the capacity of the AC
source such as a generator. The Conext SW limits the maximum input
current to this setting by derating its charging current. If the
connected loads exceed the breaker setting, the AC breaker trips.
The breaker may not trip if Load Shave is enabled and Load Shave
Amps is configured not to exceed the generator’s rated output
current.
ACIn Lo Volt
Sets the minimum acceptable input voltage level from the AC source
(generator or grid).
ACIn Hi Volt
Sets the maximum acceptable input voltage level from the AC source
(generator or grid).
ACIn Lo Freq
Sets the minimum acceptable input frequency from the AC source
(generator or grid).
ACIn Hi Freq
Sets the maximum acceptable input frequency from the AC source
(generator or grid).
Figure 4-9 AC Support Menu Screen
CSW4024E 00: AC Support
AC Supp Mode
AC Supp Volts
Load Shave
Load Shave Amps
LoadShaveStart
LoadShaveStop
AC Supp on Soc
AC Supp Start Soc
AC Supp Stop Soc
[Enabled]
[26.5V]
[Disabled]
[24A]
[12:00 AM]
[12:00 AM]
[Enabled]
[80%]
[50%]
[Disabled] or [*Enabled]
[*Disabled] or [Enabled]
[*Disabled] or [Enabled]
CSW4024E 00: Adv
Inverter Settings
Charger Settings
AC Settings
AC Support
Multi Unit Config
Restore Defaults
Adv Features
[*24A] [0A] to [24A]
[*26.5V] [23.0V]to [35.0V]
[*50%] [20%] to [60%]
[*80%] [70%] to [100%]
Follow procedures on the Conext SW Owner’s Guide to change the settings.
ConextSWEUROwnersGuide.book Page 23 Thursday, July 23, 2015 3:32 PM