Installation Manual

Installation
1–8 975-0637-01-01 Rev E
This guide for use by qualified personnel only
Xanbus Network System
Xanbus System
The Xanbus system includes the Conext SW and other Xanbus-enabled devices.
The Conext SW is the device in a Xanbus system that typically provides network
power—500 mA at 12 VDC. All of the Xanbus-enabled devices, such as the
Conext SW, the SCP, and the AGS are able to communicate their settings and
activity to each other.
The Xanbus-enabled designation (see below) means that this product works on a
Xanbus network. Xanbus-enabled products are:
Simple to operate and routine tasks are automated.
Controlled by software that eliminates analog signalling errors.
Less susceptible to interference and line loss.
Upgradable through new software releases.
Figure 1-6 Xanbus System Diagram Example
MPPT Solar
Charge
Controller
SCP
AGS
Conext SW
Xanbus Network _ _ _ _ _ _ _ _
network terminator
network terminator
Conext
ComBox
TM
ConextSWEUROInstallationGuide.book Page 8 Tuesday, July 21, 2015 4:22 PM