Manual

Turning On the Conext Gateway
Before turning on the Conext XW+, you must connect it to a power source.
Figure 9 Power connections and button
Xanbus
26-pin
connector
[A]
[B]
[C]
NOTE: In the 26-pin connector, pin 1 connects to a 9-24VDC source and pin 2 connects
to GND Power input. See "26-pin connector" on page15.
To turn on the Conext Gateway:
1. Select a power source to the Conext Gateway. You can choose either of the
following:
a. Plug the (A) AC/DC power adapter into the AC wall outlet
b. Connect the Conext Gateway to the Xanbus network (B) using Ethernet
cables
c. Provide 9–24VDC power via by connecting to a power input source via the 26-
pin connector (C)
2. Connect (A), (B), or (C)'s connector to Conext Gateway's Power port for (A), Xanbus
port for (B), or terminal block for (C), respectively.
3. Connect (A)'s power plug to an AC wall outlet or (B)'s other Xanbus cable connector
to a Xanbus port on a Xanbus device. Alternatively, connect (C)'s pins 1 & 2 to a DC-
powered device.
4. Observe the LED indicators and wait for the Power LED to light up (solid). The
Conext Gateway is now turned on.
5. Proceed to "Logging in to the Conext Gateway Web Application" on page34.
Installation Conext Gateway Conext Gateway Owner's Guide
975-0806-01-01 28