Manual

Mounting the Conext Gateway
Wall Mount
To mount the Conext Gateway on a wall:
1. Choose the location for mounting the device.
2. Using the diagram in the Conext Gateway Quickstart Guide (part number: 975-0804-
01-01), mark the mounting holes on the wall with a pencil.
3. The holes must be at the same height and 4 7/16 inches (112 mm) apart.
4. Insert the two anchors and mounting screws supplied in the marked locations on the
wall, leaving a space of about ¼ inch (6 mm) between the wall and screw head.
5. If you are mounting the Conext Gateway on concrete, the supplied anchors and
mounting screws are not suitable. Use two mounting screws that are equivalent to #6
screws.
6. Place the Conext Gateway on the mounting screws, and confirm a snug fit before
going to the next step.
7. Connect the wiring and cables.
DIN Rail Mount
To mount the Conext Gateway on the DIN Rail:
1. Use a standard 35-mm “top hat” DIN rail (EN50022).
2. You may choose to move the mounting clip to the side as shown.
3. Attach the device to the DIN rail. Hook the bottom catch of the clip onto the rail, pull
up a little to retract the bottom catch and hook the top catch of the clip onto the rail.
4. Connect the wiring and cables.
Conext Gateway Conext Gateway Owner's Guide Installation
23 975-0806-01-01