Manual

Physical Features
The following illustration shows the Conext Gateway. The tables in the following
sections contain descriptions of the connectors, indicators, and data ports on the Conext
Gateway.
Figure 2 Ports, buttons, and indicators
6
789
1312 14
10
11
5
4321
1 Xanbus ports 1 1st pair of Xanbus ports used for Xanbus communications
2 Xanbus ports 2 2nd pair of Xanbus ports used for Xanbus communications
3 Ethernet port Use to connect to the internet via an Ethernet cable.
4 Antenna Adjustable antenna for Wi-Fi transmission and reception
5 26-pin port Use for connecting the 26-pin connector.
6 LED indicators LED indicators are used for signifying device, communication, and
monitoring statuses.
7 Wi-Fi button Press and hold to turn on or turn off Wi-Fi setup network.
8 Settings button Press to enter device configuration mode.
9 Power button Press to enable/disable the Conext Gateway.
10 Power port Use for connecting the AC/DCpower plug.
11 DIN rail clip
(detachable)
Use for attaching the device to a 35mm EN50022 DIN rail. The clip
can be detached and re-attached to one of the narrow sides of the
device.
12 Reset pinhole
button
Press to reset the Conext Gateway.
13 USB port Use for firmware updates only. Do not use to charge USB devices.
14 SD card slot Insert a mini-SD card (up to 128GB) for data storage.
Conext Gateway Conext Gateway Owner's Guide Overview
13 975-0806-01-01