Manual

Changing Device Settings
975-0679-01-01 Revision D 3–35
5. Click to expand the device setting.
6. Click the check box to enable the setting. If the box is already checked then
cascading is already set up and no further action is necessary.
7. Click to save the change.
Using Copy Configuration
The copy configuration feature allows you to copy all device settings described in Table
3-1 from one device to another device of the same type on a common AC or DC
connection.
To copy parameter settings from one device to another device of the same type:
1. Put the device on standby mode. See “To set a device in Standby mode:” on
page 3–31.
2. Click to access the individual devices menu.
3. Click the device you want to configure.
4. Click in the left side menu.
You will see a list of Device Settings for that type of device.
Important: Device settings for each
Xanbus device vary. The one shown
here is for the XW inverter. Be sure
to consult the Owner’s Guide of the
device before trying to change the
settings via the Conext ComBox.
Also, when configuring the network-
managed power system with
cascading parameters enabled, you
should verify that the configurations
have been cascaded correctly to
other devices. Communication
errors may cause parameters to
revert to their original values or
generate a warning message.
Conext_ComBox_Owners_Guide.book Page 35 Monday, October 21, 2013 10:00 AM