Manual

Changing Device Settings
975-0679-01-01 Revision D 3–33
7. Change the Operating Mode parameter to Standby.
8. Click to save the setting.
To change a Device Setting after putting the device on Standby:
1. After putting a device on Standby mode, proceed to change the device’s other
settings. In the example below, the XW inverter/charger device has the following
Device Settings you can change.
2. Click the Device Setting type you want to change.
That portion of the window will expand to display the change options for that
setting. The size and content of the expanded window varies depending on the
type of setting.
3. In the expanded window, click to see the current setting. This may be different
from the value shown, if the change was made in another way – for example,
another device like the SCP was used to change the value.
4. Modify the value(s) as necessary.
5. Click to save the change(s).
Important: Device settings for each
Xanbus device vary. Be sure to
consult the device’s Owner’s Guide
before trying to change the settings
via the Conext ComBox.
Conext_ComBox_Owners_Guide.book Page 33 Monday, October 21, 2013 10:00 AM