Manual

Changing Device Settings
975-0679-01-01 Revision D 3–31
Changing Device Settings
Before making any changes familiarise yourself thoroughly with the effects of changing
the power system settings.
To set a device in Standby mode:
1. Click the Devices icon to show all Xanbus devices in the network.
2. Select the device type from the Devices screen.
Depending on your system, there may be one or more devices shown.
3. Click the device you want to change from the Devices screen above.
NOTICE
EQUIPMENT DAMAGE
• Consult the device’s Owner’s Guide when changing the device’s settings.
• Make sure the device connected on the Xanbus or Modbus network is in
standby mode before changing settings.
• Do not change any settings unless you are familiar with the device.
Failure to follow these instructions can damage equipment.
Conext_ComBox_Owners_Guide.book Page 31 Monday, October 21, 2013 10:00 AM