Manual

Configuration
3–28 975-0679-01-01 Revision D
To reset all of the device Modbus addresses to their default values:
◆ In Modbus Address List, click Reset Addresses.
Modbus Address Enumeration
Use this setting to change the initial starting Modbus addresses for device types. The
Conext ComBox automatically assigns starting addresses when it is installed but the
starting values can be changed as you wish.
Make these changes before connecting new devices to the Conext ComBox system.
When the Conext ComBox detects a new device, it will assign the address based on
the current start address setting for that device type. For example, an XW Modbus Start
Address of 10:
• The first XW discovered on the network will be assigned the address 10.
• The second XW discovered on the network will be assigned the address 11, and so
on.
The starting addresses for each device type on installation of the Conext ComBox are
listed above.
Conext_ComBox_Owners_Guide.book Page 28 Monday, October 21, 2013 10:00 AM