Manual

Changing the Time
975-0679-01-01 Revision D 3–7
Changing the Time
You can also choose to use the network time for your system. If enabled, network
time (SNTP) will override the Conext ComBox Time setting at the next SNTP
polling update. See “Using Network Time”.
The default setting has SNTP network time enabled (SNTP state is On).
To change the Conext ComBox time and/or date:
1. In the menu bar, click .
2. Click in the left side menu.
3. Under Conext ComBox settings, click Time and Zone.
4. Click to display the current time.
5. To change the Date/Time, enter it in the same format as shown
(YYYY/MM/DD HH:MM:SS) and click Set Time.
6. To set the Time Zone, select from the drop-down list and click Set Time Zone.
WARNING
PHYSICAL INJURY HAZARD
Be careful when changing the Conext ComBox time setting. It will override any
time settings on individual Xanbus-enabled devices in the network. The time
represents the entire system. Any appliance or equipment that is time-
controlled by a Xanbus device, such as a generator connected to an AGS,
can inadvertently turn on at the wrong time.
Failure to follow these instructions can result in death or serious injury.
Note: This date/time setting overrides settings on other devices in the system.
Conext_ComBox_Owners_Guide.book Page 7 Monday, October 21, 2013 10:00 AM