Installation Guide

ManualsBrandsSchneider ManualsInverter AccessoriesSchneider Conext ComBox

Changing Device Settings

975-0679-01-01 Revision F 3–41

5. Click to expand the device setting.

6. From the drop-down box, select the device to which you want to copy the

settings.

7. Click to copy the settings.

Note: Device settings for each

Xanbus device vary. The one shown

here is for the Conext XW+ inverter.

Be sure to consult the Owner’s

Guide of the device before trying to

change the settings via the Conext

ComBox.

Also, when configuring the network-

managed power system with

cascading parameters enabled, you

should verify that the configurations

have been cascaded correctly to

other devices. Communication

errors may cause parameters to

revert to their original values or

generate a warning message.

Table 3-1

Parameter Cascade Copy

SearchMode No Yes

Grid Support Yes Yes

Battery Voltage Yes Yes

Battery Type Yes Yes

Battery Capacity Yes Yes

Max Charge Rate Yes Yes

Charge Cyle Yes Yes

ReCharge Volts Yes Yes

Absorb Time Yes Yes

Dft Batt Temp Yes Yes

Eqlz Support Yes Yes

Eqlz Voltage Yes Yes

Bulk Voltage Yes Yes