Installation Guide

Configuration
3–40 975-0679-01-01 Revision F
4. Click from the menu tree below the highlighted device.
You will see a list of Device Settings for the device.
Note: Device settings for each Xanbus device vary and may not contain the
Cascading Settings option. Be sure to consult the Owner’s Guide of the device
before trying to change the settings via the Conext ComBox. Also, when
configuring the network-managed power system with cascading parameters
enabled, you should verify that the configurations have been cascaded correctly
to other devices. Communication errors may cause parameters to revert to their
original values or generate a warning message.
5. Click to expand the device setting.
6. Click the Enable Cascaded Settings (All Devices) check box to enable the
setting. If the box is already checked then cascading is already set up and
no further action is required.
7. Click to save the change.
Using Copy Configuration
The copy configuration feature allows you to copy all device settings described
in Table 3-1 from one device to another device of the same type on a common
AC or DC connection.
To copy parameter settings from one device to another device of the same
type:
1. Put the device on standby mode. See “To set a device in Standby mode:” on
page 3–38.
2. Click System Devices to access the individual devices menu.
3. Click the device you want to configure.
4. Click in the left side menu.
You will see a list of Device Settings for that type of device.