Installation Guide

Changing Device Settings
975-0679-01-01 Revision F 3–39
To change a Device Setting after putting the device on Standby:
1. After putting a device on Standby mode, proceed to change the device’s
other settings. Each Xanbus device will have varying settings which
correspond to that device. Be sure to consult the device’s Owner’s Guide
before trying to change the settings via the Conext ComBox.
2. Click System Devices from the left panel, then click the device you wish
to change.
3. Click the button of the device you wish to change to open the
Device Settings page.
4. The Device Settings are separated into categories. Click the category of the
setting you wish to change from the main window to expand the settings
page.
5. In the expanded window, click to update the current setting from the
device. This may be different from the value shown if the change was made
without the ComBox – for example, if another device like the SCP was used
to change the value.
6. Modify the value(s) as necessary.
7. Click to save the change(s).
Cascading Parameters and Copy Configuration Features
Using Cascading Parameters
Xanbus-enabled devices are typically configured one at a time. However,
because devices often have common settings, cascading parameters can
simplify and speed up system configuration. When a parameter is “cascaded,” a
newly configured device setting on one device is applied to all devices of the
same device type on a common AC or DC connection.
Table 3-1 shows which device settings are able to be cascaded. Once
cascading parameters are enabled, any change to a device setting in listed in
Table 3-1 will be automatically applied to all devices of the same type.
For example, if cascading parameters are enabled and a Battery Size (Ah)
parameter is changed on the XW inverter setup menu, the same battery size
setting is applied to other XW inverters.
To enable or disable cascading parameters:
1. Put the device on standby mode. See “To set a device in Standby mode:” on
page 3–38.
2. Click System Devices to access the individual devices menu.
3. Click the device you want to configure.