Installation Guide

Configuration
3–28 975-0679-01-01 Revision F
Modbus Address Enumeration
Use this setting to change the initial starting Modbus addresses for device types.
The Conext ComBox automatically assigns starting addresses when it is installed
but the starting values can be changed as you wish.
Make these changes before connecting new devices to the Conext ComBox
system. When the Conext ComBox detects a new device, it will assign the
address based on the current start address setting for that device type. For
example, an XW Modbus Start Address of 10:
• The first XW discovered on the network will be assigned the address 10.
• The second XW discovered on the network will be assigned the address 11,
and so on.
The starting addresses for each device type on installation of the Conext
ComBox are listed above.