Installation Guide

Changing the Time
975-0679-01-01 Revision F 3–5
3. Under Conext ComBox Settings, click Change Admin Password.
4. Enter the Old Password.
5. Enter your New Password.
The password should contain at least eight alphanumeric (0-9, a-z, A-Z)
characters with no special characters and spaces. Passwords are case-
sensitive, and the maximum length is 32 characters.
6. Enter the New Password (confirm) again.
7. Click Submit.
A message indicates that the password change was successful.
Changing the Time
You can also choose to use the network time for your system. If enabled, network
time (SNTP) will override the Conext ComBox Time setting at the next SNTP
polling update. See “Using Network Time”.
The default setting has SNTP network time enabled (SNTP state is On).
To change the Conext ComBox time and/or date:
1. In the menu bar, click the arrow to the left of ComBox Configuration to
expand the menu.
2. The Configuration menu appears. Click in the menu bar.
3. Under Conext ComBox settings, click Time and Zone.
WARNING
PHYSICAL INJURY HAZARD
Be careful when changing the Conext ComBox time setting. It will override any
time settings on individual Xanbus-enabled devices in the network. The time
represents the entire system. Any appliance or equipment that is time-
controlled by a Xanbus device, such as a generator connected to an AGS,
can inadvertently turn on at the wrong time.
Failure to follow these instructions can result in death or serious injury.