Installation Guide

Mounting the Conext ComBox
975-0679-01-01 Revision F 2–5
4. Place the Conext ComBox on the mounting screws, and confirm a snug fit
before going to the next step.
5. Connect the wiring and cables. Go to “Wiring the RS 485 Modbus Connector
for Power to the Conext ComBox” on page 2–14.
DIN Rail Mount
A standard 35-mm “top hat” DIN rail (EN50022) must be used for mounting.
To mount the Conext ComBox on the DIN Rail:
1. Choose the location for mounting the device.
2. Using heavy duty scissors or a diagonal cutter, cut both ends of the side tab
on one end of the Conext ComBox.