Installation Guide

Installation
2–4 975-0679-01-01 Revision F
Mounting the Conext ComBox
Wall Mount
To mount the Conext ComBox on a wall:
1. Choose the location for mounting the device.
2. Using the template in the Conext ComBox Quickstart Guide, mark the
mounting holes on the wall with a pencil.
The holes must be at the same height and 4 7/16 inches (112 mm) apart.
3. Insert the two anchors and mounting screws supplied in the marked
locations on the wall, leaving a space of about ¼ inch (6 mm) between the
wall and screw head.
.
If you are mounting the Conext ComBox on concrete, the supplied anchors
and mounting screws are not suitable. Use two mounting screws that are
equivalent to #6 screws.
¼ inch
(6 mm)