Installation Guide

Physical Features
975-0679-01-01 Revision F 1–5
Communication and Power Ports
See the “Installation” section for more detail on these ports.
1
23
4 5 6
Item Description
1 Power port. Use an AC/DC power adapter connected to a wall
outlet to provide power to the Conext ComBox.
2 Xanbus ports. Plug in a CAT5 cable from Xanbus-enabled devices
for communications and/or power to the Conext ComBox.
3 DIN rail sliding catch. Slide up/down to lock/release the Conext
ComBox to a DIN rail.
4 RS 485 Modbus port. Use the RS 485 Modbus connector from a
Modbus device for communications and 24V power terminals to the
Conext ComBox.
5 10/100 Ethernet port for CAT5 cable only. Use to connect to a
DHCP-enabled network router.
6 Dry Contact port. Used for signalling with SELV (Safety Extra Low
Voltage) device. It does not provide power to the Conext ComBox.