User Manual
4
Copyright © 2014 Schneider Electric. All Rights Reserved.
All trademarks are owned by Schneider Electric Industries SAS or its affiliated companies.
G
Configuring the Automatic Generator Start
Standby
Event/Warning
Conext XW SCP
System Status
Battery 20.4A 53.9V
BatLev
Load 1235W
AC1 115W 3202V
E
F
Select Device
System Settings
XW6848
MPPT60
XW AGS
XW AGS 00:Setup
Clear Faults Warnings
View Device Info
GenMode
[ManualOff]
Mode
[Operating]
XW AGS 00:Setup
Clear Faults Warnings
View Device Info
GenMode
[ManualOff]
Mode
[Standby]
Before configuring the AGS, place the unit in Standby using the SCP.
XW AGS 00: Setup
[ManualOff]
[Operating]
XW AGS 00: Config
[Enabled]
[9:00PM]
[8:00AM]
[2]
XW AGS 00: Triggers
[44.5V]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[Enabled]
[Disabled]
[Disabled]
[Disabled]
[Disabled]
[10A]
[7A]
XW AGS 00: Gen
[60sec]
[30sec]
[3sec]
[8hours]
[21days]
[30min]
[9:00AM]
[NotUsed]
[0.5sec]
[0sec]
[30sec]
[40sec]
[0sec]
[3]
XW AGS 00: Multi
[AGS]
[00]
XW AGS 00: Conn
[HouseBatt1]
[Grid1]
[ACLoad1]
[Gen1]
XW AGS 00:Setup
GenMode [ManualOff]
M
ode [Operating]
C
lear Faults Warnings
View Device Info
Load Start Delay [5min]
Start SoC [50%]
Stop SoC [90%]
Access AGS configuration settings
On the AGS Setup menu, press
Enter and both up arrow and
down arrow keys together briefly
to access the Advanced
Set the generator type
using Gen Type
On the System Status screen, press Enter
to display the Select Device menu.
Press down arrow to highlight Mode
and press Enter.
Press down arrow to toggle the setting to
Standby and press Enter. Press Exit to
go back to the previous screen.
Press down arrow to highlight XW AGS
and press Enter.
For more information on configuring the AGS, see the
Conext Automatic Generator Start Owner’s Guide.
www.SESolar.com
Conext Automatic Generator Start Quick Start Guide
865-1060-01
The AGS is configured using the AGS Setup menu on the Conext System Control Panel (SCP). On the Setup menu, you can change
configuration settings, select the generator’s operating mode, clear fault warnings and view device information.
Place the AGS in Standby