Installation manual

6
Steps for setting up the drive
b 1 Receive and inspect the drive controller
v Check that the catalog number printed on the label is the same
as that on the purchase order
v Remove the Altivar from its packaging and check that it has not
been damaged in transit
Steps 1 to 4 must
be performed with
the power off.
b 2 Check the line voltage
v Check that the line voltage is compatible with the
voltage range of the drive (see pages 9 , 10 and 11)
b 3 Mount the drive
v Mount the drive in accordance with the instructions
in this document
v Install any internal and external options
b 4 Wire the drive
v Connect the motor, ensuring that its
connections correspond to the voltage
v Connect the line supply, after making sure
that the power is off
v Connect the control
v Connect the speed reference
PROGRAMMING
v 5 Please refer to the
Programming Manual
INSTALLATION