User`s manual

3. Setup for the communication option cards

3. 13. Application-specific option cards

Refer to the Altivar 71 Programming Manual for information about how to use these different functions.

Pump card VW3A58210

This card has not been continued on the Altivar 71; this offer will be available at a later date with the range

resulting from the RSX-P project.

Multi-motor card VW3A58211

Compatibility is assured with the addition of a VW3A3202 extended I/O option card in order to access AI3

and LO and configure the Multi-motor function manually since the PowerSuite software workshop cannot

access the data stored in the old option card. To do this, in menu:

[1.7 APPLICATION FUNCT.] (FUn-) adjust [MULTIMOTORS/CONFIG.] (MMC-).

Multi-parameter card VW3A58212

This card has not been continued on the Altivar 71H.

Only the parameter switching function is integrated in the ATV71, and can be used to switch between 3 sets

of 15 selectable parameters.

[1.7 APPLICATION FUNCT.] (FUn-) then [PARAM. SET SWITCHING] (MLP-)

For other operating modes (indexing, sequencing functions, etc.), it is necessary to use Controller Inside.

Positioning card for simple

applications

VW3A58213

This card has not been continued on the Altivar 71.

The simple position control function integrated as standard in the product and requires the addition of

a VW3A3201 basic I/O option card.

[1.7 APPLICATION FUNCT.] (FUn-) then [POSITIONING BY SENSORS] (LPO-)