User`s manual

72
3. Setup for the communication option cards
3. 11. 7. Programming the Altivar 58 Ethernet parameters
Apart from the drive DHCP name ("DeviceName" parameter), all the parameters that can be accessed using the Altivar 58’s programming
terminal are present on an Altivar 71 equipped with a VW3 A3 310 Ethernet card.
They can be accessed from the
[ETHERNET] (EtH-) submenu in the [1.9 – COMMUNICATION] (COM-) menu.
The correspondence of these parameters between the two types of drive is described in the following table:
3. 11. 8. Modbus service
Available address fields
In "ATV58(F) Interchangeability" mode (SE8 mode), addresses W1 to W615, described in the Altivar 58(F) "Internal communication
variables" User’s Manual, can now be accessed in order to ensure that an Altivar 58(F) can be replaced by an Altivar 71.
In order to access these variables by means of TCP/Modbus messaging, a UNIT_ID of 0 must be used, in the same way as before on the
Altivar 58(F).
Command Description
Altivar 58(F)
Altivar 71
Graphic display terminal or integrated
display terminal
Value in …
Short
parameter name
P05/O05
1 IP address P01/O01 to P04/O04 AdrIP[1] to AdrIP[4] [IP card] (IPC-) + (IPC1) to (IPC4)
2 Subnet mask P01/O01 to P04/O04 Mask[1] to Mask[4]
[IP Mask] (IPM-) + (IPM1) to (IP M4)
3 Gateway address P01/O01 to P04/O04 Gtw[1] to Gtw[4]
[IP Gate] (IPG-) + (IPG1) to (IPG4)
4 DeviceName P01/O01 DeviceName XXXX
5 FDR configuration P01/O01 Validation
[FDR validation] (FdrU) + (NO/YES)
P02/O02 Local Config
[Ethernet local conf] (LCFG) +(OFF/ON)
P03/O03 FileDef
[FDR File error] (FdrF) + (OFF/ON)
6 FDR-Autosave
configuration
P01/O01 AutoSave
[FDR autosave] (FdrS) + (NO/YES)
P02/O02 Timer
[FDR t. autosave] (Fdrt) + 2 to 255
7 FDR status P01/O01 Action
[FDR Action] (FdrA) + (IDLE, SAVE, REST, DEL)
P02/O02 State
[FDR state] (FdrE)
P03/O03 ErrCode
[FDR Fault] (FdrD) + 0 to 65535
8 DHCP-FDR server
IP address
P01/O01 to P04/O04 Ip[1] to Ip[4]
(DHCP-FDR)
[IP FDR] (IPF-) + (IPF1) to (IPF4)
9 IP Master address P01/O01 to P04/O04 Ip[1] to Ip[4] (Master)
[IP Process] (IPP-) + (IPP1) to (IPP4)
10 IO Scanner
configuration
P01/O01 Activation
[Eth IO Scan. act] (IOSA) + (OFF/ON)
P02/O02 Time out
[Ethernet Time out] (tOUt) + 0 to 60.0