User`s manual

Altivar 58 hardware identification

Before selecting the Altivar 71, the Altivar 58 hardware configuration needs to be determined carefully.

Measure the line voltage and indicate the type of power supply:

Line voltage:_________V Single phase Three-phase

Note down the drive catalog number, which appears on the Altivar 58 nameplate:

ATV58______________________

Determine whether the drive is used with high torque (170% Tn) or standard torque (120% Tn), by referring to page 6.

High torque Standard torque

Note down the catalog number of any EMC filter installed under the drive:

VW3A584 ___________________

Note down the catalog number of any option cards installed in the Altivar 58; this can be found on the label attached to the card:

VW3A58_____________________

Note down whether the operator terminal is used:

VW3A58101: yes no

Is the operator terminal connected remotely on the enclosure

door?

yes no

For ATV-58pU09M2 and U18M2 drives, note whether a braking module is present:

VW3A58701: yes no

Note down the catalog number of the NEMA type 1 mounting kit, if used:

VW3A5885___________________

Note down the catalog number of the control card fan kit, if used:

VW3A5882___________________

Make sure you have the diagrams for the existing installation.

Input V : 200/240V-50/60Hz

Input phase : 1

Input I : 4.4/3.9A

Input fuse : Type CC or J : 6A Max

Output 3 Ph : 200/240V

Output I : 2.1A

Output I max. transient (1mn) : 3.2A

Output frequency : 0.5-320Hz

Serial N . 1703001070 France - 6W 9720

LISTED 170M

IND.CONT.EQ

Cu AWG 14 : 60/75 C : 8.9lb in/1.0 Nm

Motor Protective Device

AIC 2000 A Protection type Classe 20

For 200 V and 208 V power supply,

see user's manual WDED397048.

Kit VW3A58844 required for UL type 1 rating

N998

ATV58HU09M2

Motor Rating : 0.37 kW / 0.5HP