User`s guide

63230-216-217/A2 Basic Operation
9/2002 Using Tables
7
© 2002 Schneider Electric All Rights Reserved
Viewing Bar Charts To view bar charts (Figure 3), do the following:
1. Click the Bar Charts tab.
2. Select a device from the list on the left side of the page.
3. Select the desired quantity to view (amps, volts, etc.).
The bar charts update at the sample rate displayed at the bottom of the
Power Server Browser. (See“Changing the Sample Rate” on page 32 for
instructions on changing the sample rate.)
4. To view amps, volts, power, and power factor charts on the same display,
click the All Charts button. Scroll to view all charts.
Figure 3: The Bar Charts page in All Charts mode
Configuring Meter and Bar Chart Displays Both meter and bar chart displays support color bands to indicate normal
operating ranges. These bands only appear if you configure them during the
setup process. Find the index topic “Operating Range Indication” in
SMS-3000 Help for instructions.
You can adjust the maximum value shown in a meter or bar chart display by
setting the ratings for each quantity of that device. Find the index topic
“Ratings” in SMS-3000 Help for instructions.
USING TABLES
Creating Quick Tables The Power Server comes with a set of default tables for each device type
supported by the Power Server. You can however quickly create simple
custom tables. To do so, follow these steps:
NOTE: See “Prerequisite Information Covered in the Power Server Setup
Guide” on page 1 if you are not yet familiar with operating the Power Server.
1. Use NetMeeting to access the Power Server.
2. Press Ctrl-W to display the Power Server desktop.
3. Put the Power Server in Setup Mode.
4. Redial the Power Server in NetMeeting to reconnect.
5. Press Ctrl-W to display the Power Server desktop.
Click the
All Charts
button to
view charts
for all
quantities on
the same
page.
Scroll to vie
w
other charts.
Bar chart displays
support color bands.
See Configuring Meter
and Bar Chart
Displays.
The maximum value
shown in the bar chart
can be adjusted by
setting the ratings for
each quantity of that
device. See Configuring
Meter and Bar Chart
Displays.