User`s guide

Basic Operation 63230-216-217/A2
Using Meter and Bar Chart Displays 9/2002
© 2002 Schneider Electric All Rights Reserved
6
USING METER AND BAR CHART
DISPLAYS
Viewing Meter Displays To view meter displays, do the following:
1. Click the Meters tab (see Figure 2).
2. Select a device from the tree list on the left side of the page.
3. Select the desired quantity to view (amps, volts, etc.) from the Meters
toolbar.
The meters update at the sample rate displayed at the bottom of the
Power Server Browser. (See“Changing the Sample Rate” on page 32 for
instructions on modifying the sample rate.)
4. To view amps, volts, power, and power factor meters on the same display,
click the All Charts button. Click the quantity names at the bottom of each
meter to cycle through the various phases.
Figure 2: The Meters page in All Charts mode
Click the
All Charts
button to
view amps,
volts, PF,
and power
on the same
page.
Click the
quantity
label to view
other phase
s
in All Charts
view.
If you defined device groups
during setup, the groups will
appear in the tree.
Meter displays support color
bands to indicate normal
operating ranges. See
“Configuring Meter and Bar Chart
Displays” on page 7.
The maximum value shown in the
meter can be adjusted by setting
the ratings for each quantity of
that device. See “Configuring
Meter and Bar Chart Displays” on
page 7.