Specifications

Power Meter 750 63230-507-201A1
Section 6—Alarms 03/2007
© 2007 Schneider Electric All Rights Reserved28
ALARM SETUP When making alarm setup changes using the display, evaluation of all
alarms is temporarily suspended while alarm setup screens are displayed.
Evaluation resumes immediately upon exit from the alarm setup screens.
Setting Up Alarms The following sequence may be used to set up an alarm:
Setting Up Magnitudes and Delays After changing an alarm’s status, a screen for changing the pickup and
dropout magnitudes and delay values is displayed.
Digital
14 Digital Input OFF/ON DIGITAL INPUT S1 4115
15 Digital Input OFF/ON DIGITAL INPUT S2 4116
Table 6– 1: List of Default Alarms by Alarm Number (continued)
Alarm
Number
Alarm
Description
Abbreviated
Display Name
Test
Register
1. In SETUP mode, press ###: until ALARM
is visible.
2. Press ALARM.
3. Using the
<-- and --> buttons, scroll
through the alarms until you reach the
alarm(s) you want to set.
4. Press EDIT to change the ENABL value.
The value will start to blink.
5. Press
+ to toggle the On/Off setting.
Press OK to select. To set up magnitude
and delay values, see below.
6. Press
1; return to the SETUP MODE
screen.

/6%2#522%.4
 /+



$)!'
%.!",

!,


1. Enter the PU MAG value (pickup
magnitude). Press OK.
2. Enter the PU DELAY value (pickup delay
in seconds). Press OK.
3. Enter the DO MAG value (dropout
magnitude). Press OK.
4. Enter the DO DELAY value (dropout
delay in seconds). Press OK.
5. Press
1; return to the SETUP MODE
screen
.

/6%2#522%.4
 /+



$)!'
$%,!9


$%,!9
-!'
-!'
05
05
$/
$/


