Installation guide

Using the Configuration Wizard
975-0720-01-01 2–9
This manual is for use by qualified personnel only
f) When selection is finished, click Next. Proceed to Set the Inverter/
Charger settings on page 2–10.
Three-Phase Configuration
To configure a single-phase unit in a three-phase configuration:
g) In the Three Phase Unit Assignment window, drag and drop the units that
you want to be the phase master into the master boxes for each of the
three phases. Only one device can be assigned to be the master for
each phase.
h) Drag and drop the remaining devices into the slave boxes for the three
phases. The devices selected as master and slaves for a phase must be
physically wired to the same phase. When dragging and dropping a unit
the display on the front panel will flash to indicate what device has been
selected. The Next button is not active unless all devices have been
assigned and one device has been selected as a master for each phase.
Figure 2-10 Split Phase Unit Assignment Window (Single Phase Units)