Installation guide

Operating Conext Configuration Tool
975-0720-01-01 1–15
This manual is for use by qualified personnel only
Operating Conext Configuration Tool
USB-to-Xanbus Adapter Status
The USB-to-Xanbus adapter has two indicator LEDs, one to indicate Xanbus
activity and another to indicate USB activity. A working Conext XW/XW+ or
MPPT80 must be active to power Xanbus devices, otherwise an optional power
supply must be added to the system. (Solar Service part # 0J-921-0023-Z).
Note: If you are using an older version of the USB-to-Xanbus adapter, see
Appendix A, “Legacy USB-to-Xanbus Adapters”.
Starting Conext Configuration Tool
To start Conext Configuration Tool:
1. Ensure the USB-to-Xanbus adapter is attached to your computer.
2. On your computer’s Start Menu, click All Programs > Conext Tools > Conext
Configuration Tool.
Recommended Configuration Procedure
You can combine Conext Configuration Tool functions to configure every aspect
of the Conext SW/XW/XW+ Inverter/Charger system.
To configure an entire Xanbus network:
1. Configure the system using one of the Configuration Wizards. See Chapter 2,
“System Configuration”.
2. Configure the Auxiliary outputs of the Conext XW+ Inverter/Charger or the
Conext MPPT 80 600 and MPPT 60 150 Solar Charge Controllers. See
“Auxiliary Output Configuration” on page 3–15 and page 3–26.
Figure 1-8 USB-to-Xanbus Adapter LEDs
Green LED indicates that Conext Configuration
Tool is interacting with devices on the
Xanbus network.
Flashing red LED indicates an error.