Installation guide

Installing Conext Configuration Tool
975-0720-01-01 1–11
This manual is for use by qualified personnel only
Network
termination
The Xanbus network must be terminated at both ends. If you need to remove a
network terminator from the Xanbus network in order to add the USB-to-Xanbus
adapter to the network, ensure that the Xanbus converter’s network termination
switch is in the “on” position.
Figure 1-6 Connect USB-to-Xanbus Adapter to Xanbus Network
AC1
AC2
Event
Equalize
kW
A
Charging
!
Inverting
Standby
Event/Warning
Conext XW SCP
Charge
controller
Inverter/Charger
AGS SCP
Network
To computer
USB port
USB-to-Xanbus
adapter
Xanbus
cable
terminator
Figure 1-7 Network Termination Switch
Network termination
switch (in terminated
positin)