User`s guide

MBX Driver Help
Cyberlogic Technologies Inc. - 99 -
Determining Peer Cop Support
Before determining whether your card supports Peer Cop, be sure the card is installed
and properly configured. Refer to the Quick-Start Guide section for more information.
Note
You may use the following procedure to determine if Peer Cop is supported even if
Peer Cop was not enabled during the board configuration.
Once you verify that your card functions correctly, follow the procedure described below.
1. Start the MBX Demo program.
2. Select the [1] Set device number option and enter the device number of your
card.
3. Select the [C] Device information option.
4. Locate the Supports Peer Cop field. If this field reports Yes, then your card
supports Peer Cop. If No, then your card does not support Peer Cop.
Event Viewer
During startup and operation, the MBX drivers may detect problems or other significant
events. When a noteworthy event is detected, the driver sends an appropriate message
to the Windows Event Logger. You can view these messages using the following
procedure.
1. Open the Windows Start menu and locate the product suite you have installed.
From there, go to Diagnostics and select Event Viewer .