User`s guide

MBX Driver Help
Cyberlogic Technologies Inc. - 77 -
1. Shutdown Windows and turn off your computer.
2. If the adapter card is already installed in the computer, open the case and remove
the card. It will look similar to the diagram above.
3. Locate the IRQ jumper block on the card. Move the IRQ jumper to the desired IRQ
position.
4. Insert the adapter card back into the computer and turn on the computer. Refer to
the Validation & Troubleshooting section to verify the card’s operation.
For more information on adapter card configuration, refer to Modicon IBM Host Based
Devices User's Guide from Schneider Electric (Order #890 USE 102 00).
Bus Number
The Windows architecture allows multiple buses of the same type in the same system.
This parameter specifies the bus number for the adapter card. The default for this
parameter is 0, and in most cases should not be changed.