User`s guide

MBX Driver Help

Cyberlogic Technologies Inc. - 70 -

Setting Words Per Node To Read

Select an

MB+ Node

intended to receive global data. Click the

Edit

button or right-click

and select

Edit

from the menu. Select the number of words of global data to read from

the list and press

Enter

Specific Outputs Configuration

Note

Peer Cop communications can send up to 32 words of specific output data to each

node on a Modbus Plus network. The total amount of specific output data sent from all

applications through a single host interface adapter must not exceed 500 words.

For every specific output word configured, you can specify the default data that the

driver will use before an application overwrites it. By default, all specific output data

words are filled with 0.

You can also configure what action the driver should take when a user application exits,

either normally or abnormally. The specific outputs controlled by this application are

either left in their last state or restored to a pre-configured default state by the driver.

Setting Words Per Node To Write

Select an

MB+ Node

intended to receive specific output data. Click the

Edit Words

button or right-click in the

Words Per Node

column and select

Edit

from the context

menu. Finally select the number of words to write from the list and press

Enter