User`s guide

MBX Driver Help
Cyberlogic Technologies Inc. - 14 -
PnP Adapter Quick-Start
This section describes the procedure for adapters that support Plug and Play. To use this
procedure, you must have one of the following adapter cards.
 PCI-85 (416NHM30030 or 416NHM30032)
 PCMCIA 416NHM21234
 USB TSXCUSBMBP and XBTZGUMP
If this is not the case, go to the Non-PnP Adapter Quick-Start section.
The following steps show a typical configuration session. Use it only as a guideline of
how to configure the most common features. For detailed descriptions of all of the
available features, refer to the Configuration Editor Reference section.
The procedure is broken into several short segments:
 Creating a PnP Device
 Configuring Device Settings
 Configuring Peer Cop Communications
 Configuring the MBX Gateway Server
 Verifying Your Driver Configuration
 Backing Up Your Configuration
After completing this procedure, you will have a fully-configured MBX device and will be
able to confirm that the driver is running and communicating with other nodes on your
network.
To begin, go to Creating a PnP Device.
Creating a PnP Device
This first step is slightly different for each adapter type, depending on whether it is a
PCMCIA Card, a PCI Card or a USB Adapter.
PCMCIA Card
1. Verify that the MBX Driver software is installed.
2. Insert the PCMCIA 416NHM21234 into an empty PCMCIA socket. The system will
detect that new hardware has been added and display a Found New Hardware
message with the PCMCIA 416NHM21234 name.